Danh mục sản phẩm
Hỗ trợ trực tuyến
Hỗ trợ mua hàng

Mobile: 02436.231.170

Ms Huyền - Kinh doanh

Mobile: 0984.058.846

Tư vấn kỹ thuật Raspberry Pi

Mobile: 0862.628.846

Tư vấn kỹ thuật Module khác

Mobile: 0862.998.846

DTMF Shield for Arduino

DTMF Shield for Arduino
DTMF Shield for Arduino DTMF Shield for Arduino DTMF Shield for Arduino DTMF Shield for Arduino
Mã hàng: MLAB00577
Trạng thái: Còn hàng
Giá: 588,000 vnđ
Số lượng:  
   - Hoặc -   

Hỗ trợ mua hàng : 02436.231.170 or 0984.058.846

Tư vấn kỹ thuật Raspberry Pi và RS232/RS485 to Ethernet : 0862.628.846

Tư vấn kỹ thuật Module khác : 0866.828.846 or 0862.998.846

VUI LÒNG LIÊN HỆ ĐỂ ĐƯỢC HỖ TRỢ KỸ THUẬT VÀ ĐẶT HÀNG TRỰC TIẾP  


DTMF Shield for Arduino

Từ 2022 MLAB có thêm website mlab.com.vn với nền tảng web mới hơn, dễ sử dụng hơn cho quý khách hàng tra cứu, đặt hàng online tại MLAB. Quý khách hàng có thể mua tại MLAB tại link: (link đặt hàng)

This DTMF Shield is a Dual-tone multi-frequency signaling module decoder for Arduino With it's audio connector you can decode the crazy funny noises common phones make. If you are not sure what I'm talking about, imagine a home phone while pressing several of its keys. These Touch-Tones have a specific frequency or sound that this module can decode. This Shield is a Audio code system that will allow you to send commands to your Arduino via Audio signal.
Together with GMS / GPRS / GPS shield this module can communicate your Arduino with any phone land line or Cell phone in the world, within GSM signal range. Which goes as far as your cellphone.

APPLICATIONS

Its quite convenient to send wireless commands over audio lines, like a phone call. Connected to our GSM/GPS shield, you could just call your robot and press any button or set of buttons to enable it.
Connect DFRobot mp3 module to this board to enable audio feedback when pressing keys, or a welcome message when the phone call is established. Enable GPS geo location mapping, and DTMF moving functions to have a GSM wireless networking remote controlled robot.
Note: For use with the GSM / GPS / GPRS shield, you will need an audio cable (FIT0113)

SPECIFICATION

  • Audio socket for application
  • 37x37x9mm(1.46x1.46x0.35")
  • Speaker connector for audio sound checking.
  • Microphone connector for over the air remote control system( note, due to environmental noise, without any filtering system this method is not recommended)

DOCUMENTS

Viết đánh giá

Họ và tên:


Đánh giá của bạn: Lưu ý: Không hỗ trợ HTML!

Bình chọn: Xấu           Tốt

Nhập mã bảo vệ: